Brief Introduction Of Extrusion Granulator
The extrusion granulator is a dry granulation process that uses pressure to agglomerate solid materials. This is achieved by squeezing the material by two counter-rotating rollers, which are driven by an eccentric sleeve or hydraulic system. When the solid material is squeezed, the air between the powder particles is first removed to rearrange the particles to eliminate the gaps between the materials.
When brittle materials are squeezed, part of the particles are crushed, and the fine powder fills the gaps between the particles. In this case, the newly generated free chemical bonds on the surface cannot be quickly saturated by the atoms or molecules from the surrounding atmosphere, and the new generation When the surfaces touch each other, a strong recombination bond is formed. When the plastic material is squeezed, the particles will deform or flow, creating a powerful van der Waals gravitational force. In the final stage of the extrusion process, the energy generated by the pressure to the system forms a hot spot at the contact points between the particles to melt the material, and when the temperature drops and the material cools, a fixed bridge is formed. The extruded large pieces have a thickness of 5-20mm, and the surface density is 1.5-3 times that of the feed. The large pieces are then chipped, crushed and sieved to obtain the desired granular product.
Through a certain amount of water or steam, the main working method is wet granulation of agglomerates. The basic fertilizer is fully chemically reacted after the humidity is adjusted in the cylinder. Under certain liquid phase conditions, with the help of the rotation of the cylinder, the squeezing force between the particles of the material is formed into a ball.
Whether the value or power value exceeds the specified value, determine whether the bearing should be replaced. Regularly check the alignment between the output shaft of the main motor and the input shaft of the gearbox. The alignment must be checked after the first drive or three months after the bearing is replaced. Conduct electrical tests to determine the cause of the rotor imbalance; perform a vibration speed test on the clutch, and readjust the dynamic balance if it exceeds the specified value. Regularly check the heating and cooling system of the cylinder to ensure that the material is heated evenly and fully melted. If the power curve of the main motor and the melt pressure curve increase momentarily when the extruder is started, it indicates that the feeding amount of the feeding system is too large momentarily, and the feeding amount should be reduced.
