Daily Maintenance Of Calcium Carbonate Masterbatch Granulation Compounding Extruder
1. Transmission:
(1) Check the heating of the motor and the fuel tank;whether the bearing is locally overheated;whether there is abnormal noise in the motor and gear;whether any oil leakage happened;How the oil filter run, the gap between radial runout of the spline shaft and the top of screws.
(2) Clean the oil filter element of the color masterbatch granulation production line on time and clean the stains deposited at the bottom of the oil tank, and refuel the lubrication on time at the running part.
(3) When the new gear transmission is "running in", the new lubrication should be changed, and the new oil should be updated after each 4000 hours of operation. Machine Part Name Refueling Grade Replacement Circulating Mixer Transmission Parts No. 150 Gear Oil 4,000h Cone Dual Force Feeder Distribution Box High Temperature Butter (Grease) 4,000h Hoist Gear Transmission No. 150 Gear Oil 4,000h Twin Screw Main Gear Transmission No. 150 Gear oil 4,000h single screw equipment main engine gearbox 15#0# gear oil 4,000h granulator, containing high temperature butter (grease) 4,000h
2. Main extruder body: Check the patency of cooling circulating water, ambient temperature (usually ∠26℃), feeding condition, tube temperature, pressure, and damage to screw and barrel of the masterbatch granulation compounding line.
3. Nostrils: The damage of the porous plate’s dimension, the surface damage and the corrosion of the flow, if they are blocked thus will affect the products’ appearance and the extrusion output.
