News

Classification Of Twin Screw Extruder

1. According to the relative position of screws: engaging type and non-engaging type

2. Engaging type: partial engaging and full engaging according to the engaging angle

• Full engagement A=R+ R

• Partial engagement A>R+ R

• Non-engaging A>2R

The center distance of the two screws is A, and the outer diameter is R

The radius of the screw inner diameter is r

3.According to the different rotation direction of the screw: Corotating twin screw extruder and counter rotating twin screw extruder

4.Counter rotation: inward and outward

5. According to whether the screw axis is parallel: parallel and conical


Open and close of screw groove in engaging zone

The opening and closing of the screw groove in the meshing area refers to whether the material has a possible passage along the screw groove or across the screw groove in the screw groove of the two screws in the meshing area.(The channel does not include the gap between the top of the flight and the barrel wall and the gap between the two screw flights due to machining errors), there are vertical open or closed, horizontal open or closed several ways.

30

Conical twin screw extruder

Two root conical screw horizontal arrangement, two axis is an Angle Into the barrel, the center distance of two axis from the small to the big end increases gradually, make the transmission gearbox output shaft have two larger center distance, the transmission system of gear and gear shaft and bearing of the gear shaft radial and thrust bearings have larger installation space, It can be equipped with larger specifications of radial bearings and thrust bearings, each drive shaft has enough to meet the transmission torsion diameter, so large torsion, large load bearing capacity is a major feature of conical twin screw extruder. This parallel twin-screw extruder is incomparable.

31

You Might Also Like

Send Inquiry