News

Screw Shaft And Screw Barrel

◆ Screw shaft is the most important part of twin screw extruder compounding machine.it can directly affect extruder plasticizing and output.
◆ when the twin screw extruder start, the screw element will shear and make plastification  
◆ Due to the long-term work under harsh conditions, screw elements will get wore out.The screw flight will get small, and the gap between screw element and screw element increases, leading to the reduction of plastic extrusion output. Plastic reflux will occur, and not only the plasticizing effect is reduced, but also production capacity is seriously decreased
The allowance between screw barrel and screw shaft is from 0.3 to 2mm, generally 0.5mm. Small distance will cause wear between screw barrel and screw shaft.Larger distance will lead to a heavy leakage flow.

 
Screw Barrel
Segmented block type: the barrel of the co-rotating twin-screw extruder mostly adopts segmented block type structure. Generally, the length of each section is 4D(also 6, 8, 10, 12D), including feeding port section (multiple sections can be set according to feeding mode) and exhaust port section, and some have hole section for measuring melt temperature and ring pressure.
Integral type: conical twin screw barrel adopts the integral type, its structure is similar to the single screw extruder, the inner hole is
"∞" shape, cylinder head connection from "∞" shape transition to the circular connecting section.
Material requirements
Requirements: Strength and stiffness, high temperature resistance, chemical resistance, wear resistance, good cutting performance, good heat treatment performance.
Material: At present, the commonly used screw materials in our country are 45 steel, 40Cr, 38CrMoAl, etc.
High strength wear resistance corrosion resistant alloy steel: 34CrAlNi, 31CrMo12, etc.
It is also necessary to do surface spraying to harden and harden if necessary


Pelleting Material

characteristics

PP

Although it is difficult to stick into the screw barrel’s  inner wall.Comparing with PE,it is difficult to feed at first section.
In practice, it is necessary to do cooling at the feeding section.and modify the cooling system of the extrusion process.

ABS

Easy to feed for twin screw extruder, but easy to adhere to the root of screw shaft and screw element’s inner surface.Screw shaft should be done with a chromed surface .Screw head and feet should be designed with a larger diameter.

TPE

High viscosity; high internal friction;easy to run out of material; and lead to output
Fluctuation and material degradation. When designing the screw shaft, the vertical and horizontal dimensions of the feeder should be increased.
it is advisable to use the oscillating feeding method, and meanwhile the screw shaft and the feeding section should be coolled.a

PC

The hardness is high, and a large torque is required. Use materials with higher yield strength
(hardening stainless steel, etc.) and do the heat treatment
or surface hardening treatment (nitriding treatment)

Glass fiber reinforced material

Wear-resistant structural material

Bromine antimony flame retardant material

Use corrosion-resistant materials (such as stainless steel


Main extruder twin screw parameters
Screw diameter
The size of the screw diameter largely reflects the size of the extruder and production capacity
Center distance
The distance between the centers of the two screw shaft determines the design size of the head pressure, the outer diameter and the inner diameter of the screw
Length to diameter ratio
The L/D ratio is the ratio of the flighted length of the screw to its outside diameter.it shows the twin screw extruder’s specification and performance.

You Might Also Like

Send Inquiry