COLOWE Here To Show You How To Troubleshoot Again
COLOWE here to show you how to troubleshoot again
When rolling bearings are used in a plastic granulator, not only will it damage agricultural production, but it will seriously endanger agricultural production, therefore, immediate attention must be paid to this situation to ensure production efficiency and equipment quality. Due to the price of environmental protection plastic granulator, COLOWE---the plastic granulator manufacturer will explain the reasons and solutions in detail.
1. The bearing installation of the plastic pellet machine is not flexible enough, resulting in shaft deviation.
When assembling the press roller, do not install the bearing to death, otherwise it will lead to the deviation problem of the plastic pellet machine granulation work.
The way to solve these problems is to always pay attention to the final shaft of the press roller, even if you change a roll.
3.Plastic granulator results clearance symposium damage results slip.
During the operation of mechanical equipment, if the rolling bearing clearance of the equipment is not adjusted properly, it is easy to see that the fine particles formed during the granulation process are not evenly distributed, the total output is too small, and the roller pressure of the equipment is too loose, causing the rolling bearing to deviate easily.
The solution to these problems is to reduce the interval between the two main axes of the equipment.
2. Too much moisture in particulate material will seriously affect the ending of the story.
When raw materials are compressed by a plastic granulator, the large amount of steam generated by the product can also cause the rolling bearings of the machinery to rotate, due to the effective water lubrication during the material processing process.
One way to solve this problem is to reduce the supply of steam to the raw materials and maintain the moisture content of the raw materials within an effective range.
4. Excessive application of plastic pellet machine rolling bearings will seriously affect bearing turnover.
Over time, mechanical equipment can lead to damage to the final shaft (an important type of problem for prefabricated components), causing the final shaft to run off track, making it unable to function properly.
One good way to solve the problem of reduced efficiency in plastic granulating machines is not only to keep the equipment clean at all times, but also to replace the results with new ones as needed.
The above is the cause and treatment of the rolling bearing of the plastic granulator falling into the water, hoping to be helpful to us. If you have some places that you don't understand, you can leave a message at the same time.
